Then it is possible that the board on the DVD drive has a short in it or a blown surface-mount fuse if all of the connections to the DVD drive are secure. Eliminate the DVD drive and change it with an one that is new see if that actually works. You can either replace the entire drive, or try to find a replacement board if it does.
In the event that cables therefore the drive aren’t the issue that can cause the DVD drive not to ever switch on, then it might be a negative motherboard. It is hard to check this without getting a brand new motherboard or testing your DVD drive for a known working console. Then you will have to replace the motherboard if the drive still works on another board.
Bad information cable
In the event that disk is rotating within the DVD drive, nevertheless the system can not read it, then there may be a negative reference to the information cable. The cable is really a ZIF ribbon cable that goes through the DVD drive into the mom board. First, eliminate the DVD drive to there check the connection. Whether or not it’s fine, you need to access the text on the motherboard to ensure additionally it is safe. at this time, in the event that connections are fine, you could also would like to try a unique information cable, though it is really not most likely that the cable could be the issue unless there is certainly apparent problems for it.
Bad laser lens
In the event that Wii takes discs, but cannot read them, then there’s most likely an issue aided by the laser lens when you look at the DVD drive. Though you are able to simply replace the laser, it really is easier and much more reliable to displace the DVD drive.
This can cause disk read errors if your Wii is very warm to the touch. Then completely shut down the Wii (red LED) and allow it to cool down, and then try again if this is the case.
Wii remote and console aren’t linked
It will be possible that the Wii remote has “lost” its sync. You can easily clear all previous synced Wii remotes together with your system and reconnect the people you’re utilizing. Energy from the system and unplug the energy cable for a seconds that are few. Plug the charged cord back and turn the Wii right right back on. During the “Health and Safety” display display screen, open the little home on the faceplate for the system. Contain the red sync switch for at the very least 15 moments. All past syncs have actually been taken out of your console at this stage. This method doesn’t need become duplicated to re-sync each remote.
Take the first Wii remote you need to sync and remove the entranceway to your battery pack compartment. Press and launch the sync that is red close to the batteries. Quickly press and release the sync that is red in the system. The lights from the remote will then flash and illuminate the light that corresponds compared to that remote’s position (1, 2, 3, or 4). Continue doing this procedure for every single Wii remote in every desired purchase.
The fan may become clogged or eventually fail, causing the console to overheat, which could lead to much more serious damage to the device as the console ages.
If it bothers you, you will have to replace the DVD drive.
In the event that problems you might be experiencing aren’t covered above, see Nintendo’s Wii Troubleshooting web Page together with HackMii Troubleshooting Guide.